In order to extend service life of screw conveyor, when you operate the screw conveyor, please noted :
1. ネジ コンベヤー すべき be 開始 なし 負荷. 材料 缶 be 供給 に ネジ コンベヤー のみ 後 開始。
2.いつ ネジ 機械 is fed initially, the feeding speed should be increased 徐々に to reach the rated conveying capacity. The feeding should be even, Otherwise it will easily cause the accumulation of the material to be conveyed, and overloading of the drive device, which will cause the early damage of the whole machine.です。
3.In order to ensure that no load starting requirements, the conveyor should stop feeding before stopping, such as the casing of the material is completely lost before stopping the operation.で 注文 to ensure それ。
4. 材料 に be 搬送される shall not be mixed with hard chunks of material, to avoid the screw jammed and caused damage to the screw conveyor。
5.In use often review the working condition of all parts of the screw conveyor, pay attention to the fastening parts are loose, if found loose, then you should immediately tighten the screws to make the tightening of the machine again.で、 で、頻繁に review the working Withing Again.で、頻繁に使用 レビューする で、頻繁に レビューする。
6.特別 注意 すべき すべき 支払われる に ねじ 間 スパイラル チューブ および カップリング シャフト is loose, such as the 現象 すべき ある 停止 すぐに, 修正。
7.The cover of the screw conveyor should not be removed when the machine is in operation, in order to avoid accidents.の の。
8. 発生 of 異常 現象 in the operation of the screw conveyor should be examined and removed, and shall not be forced to run.
9.The 動き of the machine parts of the screw conveyor should be lubricated 頻繁に。
